Polymer80 PF940C 80% Pistol Frame – 3-Pack

Designed for builders who demand reliability and control over their platform, the Polymer80 PF940C 80% Pistol Frame – 3-Pack delivers three complete, unfinished frames for one efficient build project. Each frame in this polymer80 pf940c 80% pistol frame – 3-pack is precision-molded from high-strength, impact-resistant polymer and requires standard DIY finishing to accept your choice of compatible slide and barrel components. This is a factory-direct option for those who prefer to complete their own firearm frame without serialization.

Overview

The PF940C is the compact variant from Polymer80, designed to fit a wide range of aftermarket Glock-pattern slides and parts. Each 80% frame in this 3-pack arrives with the fire control pocket and trigger housing area unmachined, allowing the builder to complete the frame using basic hand tools and a drill press. All three frames share identical dimensions and material composition, ensuring consistent results across multiple builds. This polymer80 pf940c 80% pistol frame – 3-pack is intended for personal fabrication only and is not a finished firearm.

Features & Specs

• Three (3) PF940C 80% unfinished frames per pack; each frame requires drilling, milling, and finishing to accept standard Glock 19 Gen3-compatible parts.
• Manufactured from reinforced polymer with stainless steel rear rail module and locking block insert pre-installed in each frame.
• Full-size grip with textured surfaces and integrated accessory rail; compatible with standard Glock 19 holsters and magazines.

Each frame in this polymer80 pf940c 80% pistol frame – 3-pack includes pre-molded trigger guard undercut, slide stop cutout, and magazine release pocket. The rear rail system is bedded into the polymer for consistent alignment during the finishing process. Overall length is 7.5 inches with a 1.25-inch width at the slide rail. Weight per frame is approximately 2.3 ounces before parts installation.

Who It’s For

This product is suited for experienced firearm builders, gunsmiths, and enthusiasts who already possess the necessary tools and knowledge to complete an 80% frame. It is not intended for first-time builders or those unfamiliar with frame finishing procedures. The polymer80 pf940c 80% pistol frame – 3-pack allows you to produce multiple identical builds for personal use, training, or replacement purposes. If you are a hobbyist or professional who values hands-on control over the final fit and finish of your pistol frame, this pack provides a consistent foundation for your projects.

Shipping & FFL

This polymer80 pf940c 80% pistol frame – 3-pack is classified as an unfinished firearm frame and is not a complete firearm. It ships directly to your residential or business address without the need for an FFL transfer. Local, state, and federal laws regarding 80% frames vary; it is your sole responsibility to verify that possession and completion of these frames is legal in your jurisdiction. Polymer80 frames are not registered and must be completed in compliance with all applicable laws. No FFL signature is required at delivery.

• No FFL transfer required for shipment of these unfinished frames.
• Check your local and state laws before ordering; some jurisdictions restrict or prohibit 80% frames entirely.
• Once completed, the frame becomes a firearm subject to all applicable federal regulations regarding personal manufacture.